S15 Combo Pack 8 for Glock 43X / 48

Manufacturer: Shield Arms
Three S15 Gen 3 magazines with S15 +5 extensions pre-installed, plus the DUAL-FIT steel mag catch, for the Glock 43X and 48. 20 rounds each, ready to load; catch is right- or left-handed.
*
Availability: In stock
$199.95
i h
Buy now, pay later Available at checkout on orders over $150
Compatibility

Fits the Glock® 43X and 48. The Steel Catch Is Included.

This combo fits the Glock® 43X and 48, all generations. The S15 is a steel magazine, and the polymer mag catch the pistol ships with isn't compatible with it, so the combo includes our DUAL-FIT steel catch, right- or left-handed. Every magazine ships at 20 rounds. Capacity laws vary by state and city; check yours before you order.

What Is the S15 Combo Pack 8?

S15 Combo Pack 8 is three 20-round magazines for the Glock® 43X and 48, ready to load out of the box: three Shield Arms S15 Gen 3 steel magazines with black S15 +5 extensions and 12-coil power springs already installed, plus the DUAL-FIT steel mag catch they run on, right- or left-handed. That's 60 rounds across three magazines. The magazines are made in the USA and the extensions are machined in Bigfork, Montana, with a lifetime warranty and Spring for Life.

  • In the combo: (3) S15 +5 Pre-Installed mags, (1) DUAL-FIT catch
  • Fits: Glock® 43X and 48, all generations
  • Capacity: 20 rounds per magazine, 60 total
  • Catch: right- or left-handed, your choice
Ready to Load

Three 20s. Nothing to Assemble.

The S15 is the magazine that put Shield Arms on the map: 15 rounds, flush, in the slim Glock® 43X and 48. Add our +5 extension and it holds 20. Combo Pack 8 does that step for you on all three magazines.

Every mag arrives with the extension and its spring installed, so you swap the catch once, load up and go. It's a set for the range bag, the belt or the nightstand. Want a flush carry mag later? Swap an extension back to a standard S15 spring and base plate, and that mag carries at 15.

3 S15 Gen 3 magazines
20 Rounds per magazine
60 Rounds across three
USA Made, with Spring for Life
In the Combo

Three Extended Mags and the Catch

  • Three S15 Gen 3 Mags

    Steel bodies built on our patented staggered geometry, in a black Nitrocarb (QPQ) finish.

  • +5 Extensions, Installed

    Billet 6061 aluminum, black anodized, machined in Bigfork, Montana. Fitted with 12-coil power springs.

  • DUAL-FIT Mag Catch

    Black nitride steel, right- or left-handed. Also runs Glock®'s factory 15-round steel mags. Made in the USA.

  • Easy-Access Floor Plate

    Clean or service the magazine without pulling the extension. Index cuts help you strip it from a pouch.

One Magazine, Four Sizes

Every S15 Size. These Three Hold 20.

The S15 carries 15 flush, and each extension adds a size: 17 with the +2, 20 with the +5, 25 with the +10. All three mags in this combo ship at 20.

Want a pre-installed 17 instead? See Combo Pack 9. Want 20 in one piece? See the S20. Capacity laws vary by state and city. Check yours before you buy.

Why a Steel Catch

Steel Mags Run on a Steel Catch

The S15 is steel and the catch your 43X/48 shipped with is polymer, and the two aren't compatible. This combo includes our DUAL-FIT steel catch, which also runs Glock®'s factory 15-round steel mags. It's a one-time install, and our installation guides walk you through it. Another manufacturer's catch may cause reliability issues.

Compare

Pick Your Setup

Every kit below includes the steel catch. Pick the magazine and extension mix that fits how you carry.

Kit S15 Mags Steel Catch Extensions
S15 Combo Pack 8 (this page) 3 ✓ 3 × +5, installed
S15 Starter Kit 1 ✓ —
S15 Combo Pack 1 3 ✓ —
S15 Combo Pack 4 3 ✓ 2 × +5
S15 Combo Pack 9 3 ✓ 3 × +2, installed

Want a faster reload with those 20s? Add a Carry Magwell. See all S-Series combos.

Specifications

In the combo (3) S15 Gen 3 magazines with S15 +5 extensions and 12-coil power springs installed, (1) DUAL-FIT steel mag catch
Compatible pistols Glock® 43X and 48, all generations
Capacity 20 rounds of 9mm per magazine, 60 total
Magazine body S15 Gen 3, steel, patented staggered geometry; extends below the 43X/48 grip with the +5 installed
Magazine finish Black Nitrocarb (QPQ nitrocarburized) only
Extensions S15 +5, installed; billet 6061 aluminum, black Type II anodized, 12-coil power spring, easy-access floor plate, index cuts
Mag catch DUAL-FIT steel catch, black nitride, right- or left-handed; also runs Glock® factory 15-round steel mags
Magwells Works with Shield Arms Carry and Premium magwells for the 43X/48, and most aftermarket flared magwells
Made in USA; extensions machined in Bigfork, Montana
Warranty Lifetime warranty plus Spring for Life on the magazines and extensions

All Black

This combo comes in one look: black Nitrocarb magazines, black anodized extensions and a black nitride DUAL-FIT catch, right- or left-handed. Want other magazine finishes? Combo Pack 4 offers Nitrocarb, Silver Nickel or Black Nickel.

Black
Questions

S15 Combo Pack 8 FAQ

Which pistols does it fit?

The Glock® 43X and 48, all generations. For the single-stack Glock® 43, see the Z-Series. For the Glock® 19 and 17, see the DS-Series.

Do I need anything else?

No. The extensions and springs are already installed, and the combo includes the DUAL-FIT catch every magazine runs on. Pick right-handed (button on the left side of the frame, like the factory setup) or left-handed when you order.

Can I turn one back into a flush 15?

Yes. Remove the extension, swap the 12-coil spring for a standard S15 spring, and reinstall a flush base plate. Keep each extension's spring with it if you swap back later.

How hard is the catch install?

It's a one-time swap with basic tools and no gunsmithing. Our installation guides walk you through it.

Can I carry a 20-round S15 concealed?

The +5 extends below the grip, so it's less discreet than a flush S15. A common setup is a flush S15 in the pistol and these 20s as reloads.

Will the catch run Glock®'s factory 15-round mags?

Yes. The DUAL-FIT also runs Glock®'s factory 15-round steel 43X/48 magazines, so you can mix them with your S15s.

Will my polymer 10-round mags still work?

They'll run with the steel catch, but we don't recommend it for regular use. Steel on polymer adds wear to the magazine over time.

Combo Pack 8 or Combo Pack 4?

Combo Pack 8 ships all three mags at 20, assembled. Combo Pack 4 ships three flush S15s and two +5s in the box, so you can run 15 / 20 / 20 and pick any of three magazine finishes.

Does it work in a grip-chopped pistol?

Yes. A 43X or 48 converted by our S10 Grip Chop Service runs these magazines; the +5 adds five rounds below the chopped grip.

What is Spring for Life?

Free replacement springs for as long as you own your S15s and extensions. See the program.

What's covered?

A lifetime warranty against defects in materials and workmanship, plus Spring for Life on the magazines and extensions.

ODA Green

Used on: magazine extensions, magwells

ODA's (Operational Detachment Alpha) are the boots on the ground operational teams of a Special Forces Group. This color began as a special run for a deployed ODA. In continued support we have decided to continue the color as a standard offering and donate a portion of the proceeds to The Green Beret Foundation. Finish is anodized in green.

QPQ Nitrocarburizing Surface Treatment

Used on: magazines, barrels, slides

QPQ Nitrocarburizing is a type of surface treatment used to enhance the durability and corrosion resistance of metal parts. The process involves heating the metal in a controlled environment, where nitrogen and carbon are introduced to the surface of the metal. This forms a thin layer of a hard compound called "nitrides," which increase the surface hardness of the metal.

During the QPQ Nitrocarburizing process, the metal is immersed in a special salt bath and heated to high temperatures. The salt bath contains a mixture of chemicals that release nitrogen and carbon, which penetrate the surface of the metal. The process is carefully controlled to ensure that the nitrogen and carbon penetrate to a specific depth, creating a uniform layer of nitrides on the metal's surface.

The resulting nitride layer provides many benefits to the metal parts, including increased hardness, wear resistance, and corrosion resistance. This treatment helps to increase the lifespan and durability of metal parts, making them more reliable and long-lasting.

Any “scuffing” you see in the surface finish is completely normal, and will not affect the durability or corrosion resistance of the steel.

Electroless Nickel Plating

Used on: magazines

Silver electroless plating offers superior electrical conductivity and corrosion protection with excellent deposit uniformity and adhesion properties. This bright, reflective finish provides outstanding solderability and contact resistance while maintaining the consistent thickness and coverage that electroless plating processes are known for. Black electroless nickel plating provides these same exceptional deposit properties - including lubricity, hardness, and corrosion resistance - but with a fully conductive and uniform black surface finish that combines superior performance with an attractive dark appearance.

Products specifications
Firearms Manufacturer Glock
Firearms Model Glock 43X/48
Installation Help

Not sure how to install this product? Our step-by-step guides and video walkthroughs make it simple.

View Installation Guides →
Customers who bought this item also bought
SA Premium Magwell - Glock 43X/48 - Black

Premium Magwell for Glock 43X / 48

Our widest magwell for the Glock 43X and 48, CNC-machined from 6061-T6 aluminum in Bigfork, Montana. Drop-in install with included hardware; runs S15, S20 and factory mags.
$79.95
PMAG® 30 AR/M4 GEN M3 w/Window (30 Rounds): 5.56x45 NATO (.223 Remington)

PMAG 30 AR/M4 GEN M2 MOE - 30 rds - 5.56x45mm / .223 Remington

Magpul PMAG 30 AR/M4 GEN M2 MOE 30-round polymer magazine for AR-15/M4. Proven reliability, anti-tilt follower, enhanced grip texture. Military tested.
$12.95
S15 Combo Pack 1 - Nitrocarb

S15 Combo Pack 1 for Glock 43X / 48

A full Glock® 43X / 48 carry setup: three S15 Gen 3 15-round steel magazines and a DUAL-FIT black nitride steel mag catch. 45 rounds, all flush. Made in the USA.
$121.95
Shield Arms S15 +5 Magazine Extension - Black

S15 +5 Magazine Extension for Glock 43X / 48

A billet aluminum +5 extension that takes a Shield Arms S15 magazine from 15 to 20 rounds in the Glock 43X/48. The 12-coil power spring is included. Your S15 runs on a Shield Arms steel mag catch.
$39.95
S15 Combo Pack 6 - Nitrocarb

S15 Combo Pack 6 for Glock 43X / 48 – 10 S15 Gen 3 Magazines

Ten S15 Gen 3 15-round steel magazines for the Glock® 43X and 48, in black Nitrocarb. 150 rounds, all flush. Requires a Shield Arms steel mag catch, sold separately.
$294.95 $249.95

FREE SHIPPING FOR ORDERS OVER $100!